What you need to hold the pulley is a form of the old oil filter wrench, a bar with a rubber tail which wraps round and is secured back to the bar Something like this is sold these days as a "Boa Constrictor" for holding almost anything. If the pin is plastic it is most likely a form of nyloc locking.Ĭan you see if the nut is right or left hand thread? Geoff - Treatment has floored me today, so brain refuses to co-operate.Ĭould you get a vee belt of the correct cross section and wrap it fully round the pulley and sandwich the two "loose" ends over a flat bar - then pull the wrapped belt tight around the bar with a jubilee clip and use it as a wrench to hold the pulley - then use a spanner/socket on the nut - the nut may be a type of nyloc fitting I guess.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |